You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

This page describes how AgenPro can be used to simulate MIB modules for:

  • verifying the design of the MIB module(s)
  • finding out how to best manage devices implementing the simulated MIB module(s)
  • providing a mocku-up of a real device while its implementation is not ready yet. 

How-To Simulate MIB Modules with AgenPro

After having installed AgenPro:

  1. Run AgenPro (make sure that the MIB repository that comes with AgenPro is installed and if not set with File>Set Repository.

    Reuse MIB Repository of MIB Designer

    If you have created your own MIB module(s) with MIB Designer you can directly use the MIB Designer installation's MIB repository. Simply switch to that repository with File>Set Repository and select the repository directory used by MIB Designer.

  2. Compile the MIB module(s) to simulate with File>Compile New MIBs. Skip this step if you are reusing a MIB repository that already contains the MIB modules you want to simulate.


    AgenPro Sorts MIB Files

     

  3. Open the compiled MIB modules (i.e. load them into AgenPro from the repository) by using File->Open/Close MIB: Shuffle all the modules you want to simulate into the right list, in order to load them:


  4. Open an existing code generation project depending on the target programming language with Project->Open. 
    If you only want to simulate MIB modules, the code generation templates you choose are not relevant and can be left empty, but you need to define a project though.


  5. Edit the project using the Project Wizard with Project->Edit.
    For simulation of a SNMP agent, the first two steps are not relevant.

    1. In step (1) specify the root directories for template and in-/output paths (you will need those paths for being able to actually generate code)



    2. In step (2) specify additional properties for the code generation jobs (not relevant for simulation):


    3. In step (3) you can specify an AGENT-CAPABILITIES. Often an AGENT-CAPABILITIES statement providing a detailed description of the agent capabilitiies (i.e. support MIB modules and objects) does not exist. Only if such a statement is contained in the loaded MIB modules, then you cannot select such a statement and use it for defining the MIB modules/objects of the agent. The below screenshot shows the case when there is no such AGENT-CAPABILITIES statement available:
    4. In step (4) you specify the MIB modules for which code should be generated. In addition, when running the simulation agent, only those MIB modules will be simulated which are selected here for processing (or by the AGENT-CAPABILITIES statement from step 3):
  6. Configure the simulation agent parameters on the Agent tab. The minimum settings are the local IP address (0.0.0.0 should be fine in most cases) and the port:

  7. Run the simulation agent with Agent->Run Agent.
    The Start button of the agent panel is shown as "pressed".

    Inspect the Log panel

    The Log tab shows details about the agent start. For example you can find which objects from the source modules are simulated:



 

  • No labels